20 results in 0.0141 seconds.
-
Command Bridge vs Motor-yacht-gctid826522
I was wondering, what is the major differences between a 3788 command bridge and a 3988 motor yacht. In the 1997/2000 range. I have owned a 1989 MY for... -
Lars, may I ask for the tables dimensions?
Thank you,
katrandue... -
I have a pair of cast iron exhaust elbows that still have some life left in them. I am in So.Cal....Leave a comment:
-
Whiskywizard,
Would it be possible to post the color and measurements of the furniture on the stbd side? One other question, how did you...Leave a comment:
-
I just made these with 3/8 starboard. Router and a table saw. Material cost was about $75.00.
Attached files
...Leave a comment:
-
Heritage Yacht Sales Long Beach, Ca. has a 1992 4387 listed for $69,500. Looks like a pretty clean boat, at least on the outside. I have not been aboard....Leave a comment:
-
Earl,
Count me in. I'll see you next spring, hopefully you'll have them by then.
katrandue 1989 3888
Randy
...Leave a comment:
-
I have seen that issue mentioned in this forum before. My 1989 3888 did it until I added two 6 volt batteries on the port side. Sits pretty well even...Leave a comment:
-
Young Gun performance coatings in Rancho Cucamonga, Ca. 909 944-4156. Earl and I had 2 sets of mani-coolers done there last year. Very satified.
...Leave a comment:
-
I have been searching for a GPS antenna for my Raymarine C80. The earlier GPS antenna models up to the Raymarine 125plus are nearly impossible to find...Leave a comment:
-
I am intrested if they are still available. Where are you located, and how much.
[email protected]
909 6460205...Leave a comment:
-
Check the secondary fuel filter on the motor for trapped air, bleed it to see if air is locked inside. I found air in mine and it was doing the same thing....Leave a comment:
-
I just replaced the 80 gallon aluminum freshwater tank in my 1989 3888, it was leaking. I understand these tanks are notorious leakers at this age. The...Leave a comment:
-
Thanks to everyone for their interest and feedback. The propellers both had cloth mattress material wrapped tightly around them. I idled back to my slip...Leave a comment:
-
Propeller shaft vibration-gctid438363
I have noticed some vibration at about 1800 RPM and above after running over a mattress "of all things" last summer. Both props were involved...
Leave a comment: