That looks really nice and is undoubtedly an easier conversion than installing a propane range. Good job Pete!
Greg
500 results in 0.1708 seconds.
-
Several days after using PB Blaster I had to carefully break the old bulb and then use needle nose pliers to remove the bulb base. Not first choice,...Leave a comment:
-
Just a suggestion... after installing the proper anodes, mask the anodes and paint shafts, props, rudders, and trim tabs with 'Prop Coat' or similar...Leave a comment:
-
A mechanic with many years experience on rusty old cars taught me that impact wrenches are more likely to break rusted bolts than loosen them. Heat the...Leave a comment:
-
If you end up needing new exhaust elbow/risers let me know at [email protected]. I had some custom made out of 1/4" stainless steel for a lot...Leave a comment:
-
Go to a good full service locksmith. They should be able to make you new keys. That is what I did. Cost less than $20 usd for two keys.
...Leave a comment:
-
The Baldwin BF940 do work. I have been using them on Mr. Darcy for a few years. No problems. I usually order 6 at a time and get a very good price...Leave a comment:
-
I thought about that too. This way uses an existing pump and has a huge capacity for washing the windshield of salt spray. Simple install. For winterizing... -
No spray heads, just a 3/8 vinyl tubing that terminates next to the wiper pivot. Solenoid was off amazon. a 3/8 12vdc unit. -
There should be a gasket on the pivot shaft penetration. It might need replacing. I also used Life Calk to set mine.
Greg...Leave a comment:
-
3270 fresh water windshield washer
Installed a T in the fresh water pressure line and a solenoid valve to have fresh water routed to the top of each windshield panel by each wiper pivot.... -
Custom fabricated 304 SS exhaust risers for Hino 110 HP
After getting quote from a couple of companies for new exhaust risers at gold plated prices it occurred to me that there must be someone who could fabricate...
-
We use a pur faucet mount filter on Mr. Darcy. It filters out chlorine, lead, and about 70 other contaminates. The filter housing is about $30 with...Leave a comment:
-
[QUOTE If you over tighten, the stuffing box will easily heat to over 30 degrees C which will ruin your shaft in no time. [/QUOTE]
Is this...Leave a comment:
-
A few commercial fishing acquaintences have told me that if it drips one to three drops a minute at rest then it is adjusted right and the seal will run...Leave a comment:
Leave a comment: