fritzman
Supporting Member
Last Activity: Yesterday, 07:28 AM
Joined: 10-19-2010
Location:
-
Thanks, yes at times running a chop gun it will pile up, then it is up to the man with the roller to pack it in tight with out air bubbles.... -
Check Great Lakes Skipper, or other marine supply stores, some parts are no longer out there so you will need to update.Leave a comment:
-
Great point of view, I have one question what DIA. is the tube in your installation?Leave a comment:
-
If your handy install a electric priming pump, with a bypass 2 valves to have normal flow but when required turn on the elect pump, needs to be in front...Leave a comment:
-
Very nice job and glass work looks professional.Leave a comment:
-
We need a bit more information, What model boat, what engine, on board tank?Leave a comment:
-
Welcome to the forum.Leave a comment:
-
Welcome to the forum.Leave a comment:
-
Progress, fine job keep it up.Leave a comment:
-
I the Flow scan system my problem, I have installed a Lowrance touch map system with Gps all the connecter are mullite prong connectors Flowscan ha only...Leave a comment:
-
Nice job - Polyurethane or Gel coat?Leave a comment:
-
Yes you can, it will require changing steering wheel and all the hyd. spool valve is connected to the wheel back of the dash. check Teleflex systems.Leave a comment:
-
James, stick with the Epoxy yes it is stronger bond and I explained how to deal with the Gel coat. The alternative is Vinelester, this resin is a cross...Leave a comment:
-
Great and enjoy the grinding, Ha. any questions post and we will help.Leave a comment:
-
Picked my boat up there in 1993, The Trailer I had prebuild and it fit with adjusting the front brace, big overhead crane rolled it in to position and...Leave a comment:
-
Now the process, over the body filler ( need to have covered all the Epoxy with filler, Gel coat will not bond well to Epoxy) Yes there is primer, but...Leave a comment:
-
So to continue, we will start with the lip on the under side, you have drilled small guide holes for the screws from the bottom, right? OK mix up a small...Leave a comment:
-
Yes one more bad, gas tank install, you are on track for putting it back together, when repairing a cut out section, create a lip under the edge so that...Leave a comment:
-
Kevin, enjoy and be safe.Leave a comment:
-
The expansion in your tank will be greater the if you had a can sitting, as pointed out by Mike, I have seen in the past gas seep from the vent, sitting...Leave a comment:
No activity results to display
Leave a comment: