When the pump ran continuously on my boat, I found debris in the check valves.
BTW, the pressure switch Floatyerboat referred to is similar...
SuperiorDiver
Seasoned Member
Last Activity: 04-13-2021, 04:29 AM
Joined: 03-21-2007
Location: Houghton, MI. Most boating is around Isle Royale National Park
-
Back in the 80's when our marina switched to ethanol fuel, the only issue we had was a gelatin type substance in the carbies of the main,engines, generator...Leave a comment:
-
Sorry, I cannot explain the churning or higher temperatures, I am just regurgitating information from Timken.
Your questions should be directed...Leave a comment:
-
Some wipers have a switch to keep the wiper running to "park" even if the main power is removed. Is it possible that switch has failed and...Leave a comment:
-
I have been successful cleaning headlight covers with car polish as well.Leave a comment:
-
From Timken's site: The housing should only be half full of grease. Too much grease causes churning and higher temperatures.
That agrees...Leave a comment:
-
Interesting, and like the idea of flushing old grease out.
But when I used to do bearing design, the manufacturers advised not to fill the...Leave a comment:
-
For my 4087, I used Stan Pro 75000638 (AS1528) or Austin Hardware 800 821 3520 to replace the window run channels. The P/N for your boat may be different,...Leave a comment:
-
Going from memory, the switch is a double pole double throw, if it used for the nav. and anchor lights. If you remove the present one, it would be easy...Leave a comment:
-
Had an issue with the preheater on my 4087 when I purchased it. Spoke with a Cummins field repair technician about replacing the ECU. He said in the...Leave a comment:
-
Had a rub rail leak in the aft cabin of our 4087. Found a couple of the screws loose, luckily they were where there was access.
I removed...Leave a comment:
-
Thanks again.
It sounds like he has made a decision to go with marine Al. manifolds. Hasn't had luck with CI ones, or the local salvage...Leave a comment:
-
Tommy T, my friend emailed me that he organised one from flea bay, removed the sheetmetal plate under the crossover, it was rotted out.Leave a comment:
-
The hose bulging could be as egbauman described. Be sure the hose is a marine reinforced type.
After you verify the steering reservoir fluid...Leave a comment:
No activity results to display
Leave a comment: