Boat boy
Boat boy
Fresh Face
Last Activity: 08-09-2022, 01:30 AM
Joined: 07-23-2022
Location:
-
Ok Ok. You fine folks were so very helpful and I so appreciate it. I reved ya a little but I was just joking around. I said what I said because I was... -
Ok so perhaps I'm am too new to , how did you put it bounty, "get the panties in a wad"?? For what it's worth I was just hacking on ya. ...Leave a comment:
-
Yeah.....ok ...soooooo ...
dktool The cylinders are .030 over. I reused the cam. Honing done at the shop etc...
builderdude...Leave a comment:
-
Yes it is a brand new head gasket. Thank you sir.
No offence taken.Leave a comment:
-
Really? I can get the rust off. I was worried that they were no good. Ok so where can I get this thread sealant?Leave a comment:
-
Bad news gentlemen. To keep the push rods, rockers and plunger in order I bored holes in a block of wood and stored them in a dry place . Apparently there...Leave a comment:
-
Well thats just plain ole good intel. Thanks 2850Bounty And thanks to all of you. I am so glad I found this forum. I had joined others and got bad ju... -
Yes I have a a good marine head gasket and I am going with no sealant.
The manual says use thread sealant on the head bolts. What's that...Leave a comment:
-
I have another question I have a cheap somewhat vague manual that says not to use any permatex with the head gasket . I read on the World wide web and...Leave a comment:
-
I thank you gentleman. I ended up choosing 2 out of the 3 looked to be in better shape on the outside. Took both apart and it was very clear which one...Leave a comment:
-
After a quick search of the world wide web. I found this pump listed as cheap as $28 for a used one. And as high as $300 for what I guess is a new one...Leave a comment:
-
Ok.... I did not mean to cause a fuss. However I did take the following; No I do not need a gasket which I guess means a metal to metal seal or not to...Leave a comment:
-
Oil pump in a Mercruiser 3.0.
I am assembling my 1st boat motor. I am ready to install the oil pump, I have 3 used pumps to choose from. Is there a gasket at the mounting surface?... -
Hello. Lake Sydney Lanier is where I hang. Mercruiser 3.0
There is something about tearing one down, building it back up, installing it and it actually works after some trial and error. Getting out on the water...
No activity results to display
Leave a comment: