Ditto what Nauti_Mike said about seat choice.
3270carmine
3270carmine
Supporting Member
Last Activity: Today, 05:30 AM
Joined: 09-19-2021
Location: Easton Maryland
-
Looks fantastic. I wish I had your "limited skills"!
Ditto what Nauti_Mike said about seat choice. -
Thanks, headed to boat tonight...Leave a comment:
-
Very glad you found it! Thank you for sharing that info!!!
Leave a comment:
-
Thanks for the pictures. It looks like the "hazard" illuminates if the "ground" bus becomes energized.....based on what I think I...Leave a comment:
-
Hazard light help
Just got to boat and found the "hazard" light lit on the A/C panel board. The issue appears to be the on board charge I'm guessing (since that's... -
I've seen your pics of the aluminum skiff that you posted during your trip south!!!!! Nice!! -
I was going to suggest heat but was concerned that there may be an o-ring or seal of some sort in the block which may become damaged....Leave a comment:
-
Thank you!!! I'll give it a try...Leave a comment:
-
Lowrance help
I purchased a used Lowrance hds 7 and hds 7m.
Apparently I've missed something while setting them up.
They are on a NMEA2K network and have... -
Do you have or can you borrow an electric impact and socket? Since its the port engine there is probably enough room....Leave a comment:
-
Will your new sender screw in to that nut?Leave a comment:
-
Can you post a picture of the part you are removing?Leave a comment:
-
Mine unscrewed fairly easily. Perhaps you could get a short pipe and slide it on to a socket wrench handle....or use a breaker bar with socket.Leave a comment:
-
Uncle_Bob thats exactly what I did. 👍
Nofancy, new transducer cable from cave to lower helm area, sonarhub. From there to bridge 2 cables....Leave a comment:
-
👍Leave a comment:
-
3270, wires from cave to bridge
Adding wires from cave to bridge and had to cut a few holes. The existing wire passages were jam packed. Found a factory molded riser tube behind/above... -
I called Faria about replacement drive key. They told me I needed to find out why they break. Ah, gee...maybe because someone at Faria thought it was...Leave a comment:
-
Pictures?
black hoses, most likely filled with engine coolant. Supply and return to heater core under step to galley. Other 2 to hot water heater........just...Leave a comment:
-
Here's a post which may help
Hi , I did it the work
the longest part was getting the tank from coastline 31/2weeks
I went through...Leave a comment:
-
I'm seriously considering using a piece of Azek trim board and making my own.........maybe. Only issue is I already have about 327 projects in front of...Leave a comment:
No activity results to display
Leave a comment: