Papa_Charlie
Guru
Last Activity: Today, 06:33 AM
Joined: 05-25-2009
Location: Evertt, WA
-
I have to trim my hatches to accept the carpet and have been told that I need 1/2" all the way around. This may require additional support ledge... -
I replaced my door latch on my 4588. It is the same latch that is used on the 3218. I think I still have it. If I do, would you be interested in the entire...Leave a comment:
-
The charge does not seem out of place for a yard. However, for the future, sit down and discuss what you want done and what each item will cost you or...Leave a comment:
-
Nice pictorials.
I fully agree with NickP, you should use momentary thrust in this maneuver and for that matter every tight space maneuver you do....Leave a comment:
-
Too bad you couldn't find a poly tank to replace the aluminum one. Good luck on your project.Leave a comment:
-
Nice video. I assume you will have the tank connections welded in with threaded inserts flush with the tanks top so you can screw 90 degree elbows after...Leave a comment:
-
Do you plan to square off that fiberglass wall before tiling or will you tile to the contour? -
Our last boat had the dual voltage frig. Hated the moisture that built up and made the produce go bad very quickly. Plus didn't like to defrost the freezer...
Leave a comment:
-
I replaced both of mine when I bought the boat 8 years ago. Just replaced them again over the winter. For ~$300 each, it is pretty good insurance and...Leave a comment:
-
I am very sorry to hear about the loss of your boat and more over the loss to your son. It sounds as though it was a special time in his life.
I...Leave a comment:
-
As with most boats, the owners have had upgrades made. I believe that most have been done by yards, but that doesn't guarantee that it was done correctly....Leave a comment:
-
I will try that. I checked to see if there was a fault in my ground with the special pig tail i have that separates the three lines (LIne, Neutral and... -
Actually, the legs of the splitter won't be balanced. Each of the legs from the splitter to the boat feed different distribution panels, my boat has three...Leave a comment:
-
Manual Oil Changer/Extractor, 6.9 Quart
Moeller Manual Oil Changer/Extractor, 6.9 Quart
I purchased this a few years ago and used it twice to change the oil on my boat, but then... -
Washer/Dryer Combination Cabinet Teak Door Assembly
We have long upgraded our combination Washer/Dryer to a stackable system. I kept the door assembly because i thought I would use it for a project some...
-
Well I removed the extra line from the dock and the splitter on the dock and have all three systems on the boat paralleled off the one line. No amperage...Leave a comment:
-
Electrical Issue
I received a notice from the marina that I was bleeding electricity back into the dock through my shore power cord.
Generally AC electricity... -
That looks amazing. What would it cost to do the cockpit and swim step alone? Can you provide your contact for this product?
Thank you.Leave a comment:
-
I had mine jam once also. Trying to remember what I did to resolve it. It wasn't like it was one of those light bulb on moments, the door has to be closed...Leave a comment:
-
We get what we believe to be mold on our swim step. They are hard, not tar like. Very difficult to remove. We have tried many different things, Magic...Leave a comment:
No activity results to display
Leave a comment: