Thanks for the replies guys.
at 700 I definitely have no rattling or very faint to where I'd have to listen for it - I checked yesterday...
sharpx
Frequent Contributor
Last Activity: Today, 10:29 PM
Joined: 01-26-2021
Location: Vancouver, BC
-
thanks Pete. Was rattling quite a bit at 540 rpm, at 680ish can't hear it unless I'm next to the engine/transmission in the engine room so I'm going to...Leave a comment:
-
Hino EH700 Idle speed
I just checked the idle on both my engines (on a Bayliner 3818) and found both set to 540rpm (both the same, checked with a laser tach) - I looked in... -
Looking for an upper helm seat. looks great thoughLeave a comment:
-
I'll send a PM -
I wouldn't remove it.
there is a momentary push button on the.DC breaker panel that looks the same as the horn one at the DC switch panel,...Leave a comment:
-
thanks for the pics. How much and where are you located?Leave a comment:
-
WANTED: used helm seat
Long shot but if anyone has a decent helm seat / Captain's chair for sale let me know, looking at replacing the stock 3818 one on the bridge, nothing... -
what's the reason for not be able to charge the lifepo4 with the alternator? I'm assuming you will have a BMS in series for protection. I'm not saying... -
x2 - that was the issue on my port alternator (alternator was good), jumping the 2 terminals on the interrupter will show if it's broken if it starts... -
How do you guys prime these filters that don't have a built in priming pump? I'm contemplating replacing the stock ones on my 3818 with the 900 style...Leave a comment:
-
yeah, i'll change to the 900FH style filter, hope that will do it, the frustrating part is that is not repeatable
Maybe I will close the... -
Jim, you're correct - no reason for someone to shorten the tubes but I have seen so much technical notknowhow on this boat that I am thinking of all scenarios.... -
there isn't really a positive at the sender, you only have 1 wire coming from the sender which gives a reference to ground, you can't switch the 2 unless... -
And another question - any of you looked at or used an inline electric priming free-flow pump before the filter? Is that a good/bad idea?Leave a comment:
No activity results to display
Leave a comment: