Welcome aboard!
If you have a multimeter and know how to use it, and can still get to the wires where you hooked the new pump up, test for...
C-ya
Supporting Member
Last Activity: Today, 06:41 PM
Joined: 11-23-2019
Location: Saint Joseph, MI
-
noah2858, enjoying the blog. I'm a few days behind now so I have to get caught up. -
Is it open-bottomed like these - https://www.walmart.com/ip/4Pcs-Mari...ies/442485684?...Leave a comment:
-
Fellow posters here, Diamond_Lil, have taken several trips in their 38 footer. Here is a link to their book series https://smile.amazon.com/dp/B089DM...Leave a comment:
-
Welcome from SW Michigan! St. Joe here. I can't answer any of your questions about the 2452 except that the price does seem high.
We bought...Leave a comment:
-
Neither carb had the lockout pin.
I'll check the operation next underway. I'm sure it is fine, but I'm curious as it isn't the same as the...Leave a comment:
-
I think you are right. I went back to the carb thread and the choke was mentioned there. https://www.baylinerownersclub.org/f...rrent-topics-g...Leave a comment:
-
So here is what I found. Like I found and mentioned in the other thread, the secondaries are not locked mechanically to the primaries like my previous...Leave a comment:
-
Thanks. I'll check carb movement this afternoon. It just seems the lever movement is excessive....Leave a comment:
-
Single lever throttle movement - how much is too much?
How much should a single-lever throttle lever move before the carb starts reacting? I'm at the position shown here
before the... -
A sister boat, the USS Silversides, was towed into Lake Michigan for the 2002 movie "Below" https://en.wikipedia.org/wiki/USS_Si...ilm_prod...Leave a comment:
-
Rather than start a new thread, I'll update this one since it details my progress. I got a remanned marine carb from an outfit in FL and put it on a couple...Leave a comment:
-
2850Bounty, thank you. I'm going to a couple stores this afternoon, so I'll see what I can grab. -
Is this a tapered thread or straight? I have a short pipe in this position and the threaded end that the cap goes onto has damaged threads so I need to...
Leave a comment:
-
Luckily these engine setups have a nice loop on the alternator bracket for getting the belt tight. At least mine does. I'm guessing VP would have done...Leave a comment:
-
I dropped a small block Chevy into an Isuzu Hombre (aka S-10). The donor engine was from a van and was V-belt. I wanted to go serpentine, so I had to...Leave a comment:
-
I use the square head for my exhaust plugs. With the correct size open-end wrench, you won't round it. My garboard drain plug (main plug that you better...Leave a comment:
-
Sounds like a plan. Just make sure you have towing included with your insurance or a separate tow policy. I have an old, small boat, and I have a Progressive...Leave a comment:
-
Sold!Leave a comment:
-
I think that is what was happening with mine. I have a 1984 with a 305 and a Qjet. Before I reset the timing to what it should be, she started up nicely...Leave a comment:
No activity results to display
Leave a comment: