Metrodriver
Metrodriver
Guru
Last Activity: Today, 01:50 PM
Joined: 07-21-2019
Location: Mountlake Terrace, WA
-
Wife found a Samsung Tab 4 which is 8" tall, and almost 5" wide. Sadly the bezel is white... Android 5.1.1 good enough for Navionics and my... -
Near LA Marina Del Rey is nice.Leave a comment:
-
Nice work! We used the same sunbrella fabric you have on your little pillows for our v-berth, all with dry-fast foam and thanks to Sailrite.com and their...
Leave a comment:
-
Ahmm, close to it. When I got my boat I could not remove the drive shaft. It was seized in the gimbal bearing which was seized in the tranaom shield....
Leave a comment:
-
I sprayed corrosion-X in my plug to clean up the contacts.
I fly old large aircraft and quite often we have wires broken at pins inside connectors....Leave a comment:
-
Don't see a problem with wearing a bikini in public either. Just today I saw 2 girls pushing their bikes up the road towards town from the beach just...Leave a comment:
-
I know I will. I think I got that picture from you, and mine looks like that. The shift dog on the drive is set correctly, that got done during the rebuild....Leave a comment:
-
From reading your posts, it looks like your cables are out of alignment. With the prop in neutral, look at where your throttle is sitting, and how the...
Leave a comment:
-
Was there another guy? I am too easily distracted I guess.
On further review, yes, you are right. I think some of them might have had a crashing... -
But without his shades.... mister cool no more. -
Dktool: something to make the monkeying part easier:
https://www.boatoutfitters.com/flexs...tm_source=Face...Leave a comment:
-
Mooi gedaan!Leave a comment:
-
There are clamp-on rod holders that you could attach to your engine protector or ski tower. Other than that there is a glue-on mount base from Railblaza...Leave a comment:
-
The base plate is supposed to be bolted onto a vertical wall, then the rest of it is screwed onto that base plate. This does require drilling holes and... -
https://acrobat.adobe.com/link/revie...0-5fff1b5fe817 see if this link works. Boat specific manuals can be...Leave a comment:
-
Thanks everyone for the advice! I will leave some slack in the chain when launching. And find a way to get up on the bow.... You also confirmed my suspicion...Leave a comment:
-
I have wondered how people launch their bigger / taller boat if there is no dock... I have no room at the top of the post to use that as a footstep,...Leave a comment:
-
How much of the chain should I release before the top of the ramp? Now, on the trailer on flat land that chain is tight. I don't want it to become overtight...
Leave a comment:
-
Launching from a roller trailer.
I have a roller trailer and wonder how to launch the boat. Some videos from Boatrexam tell me to drive the trailer into the water until the wheel bearings...
-
I think if your exhaust is rusted through you'd find water in the oil.Leave a comment:
No activity results to display
Leave a comment: