cosmo777
Senior Member
Last Activity: Yesterday, 07:46 PM
Joined: 03-07-2007
Location:
-
To give you some ideas for the holding tank gauge, I took the old holding tank panel and drilled a hole and square to mount the gauge and switch. (As...
-
I measured mine today, its about 14" outside to outside. So far the 12" has worked like a champ, other than every holding tank carries a little... -
Yes, the first two were water sensors. I didn't change the fuel sensors since I have Floscans installed.
For the water sensors, I used the existing... -
Just found the sensors I purchased:
- WEM SSL19
- WEM SSL10.5
- WEM SHS12 (holding tank)
- WEM HTG (holding tank gauge)...Leave a comment:
-
There are WEMA sensors for water tanks and a different one for the holding tank. Water tank sensors have float that moves up and down on a shaft. The...Leave a comment:
-
For the holding tank sender, under the starboard salon settee there is a small carpeted hatch (about 5"x5"). This hatch is for access to the...Leave a comment:
-
To give another perspective on the issue of current leakage on a shore power connection, I had this recently tackled by an electrician. There are a few...Leave a comment:
-
Right now, there are some sale prices on Magnum inverter/chargers at imarineuas.com that look pretty competitive.
I bought my MS2812 from them 5-6...Leave a comment:
No activity results to display
Leave a comment: