Announcement
Collapse
No announcement yet.
User Profile
Collapse
-
No the voltage fluctuates like this when RPM is constant, or close to constant. I’m suspecting the uneven idle to be caused by the voltage fluctuation...
-
I decided to cut the plug and connect the wires. Everything went well. The boat is running on mufflers as we speak, and has been for 45 minutes. I used...
Leave a comment:
-
I'm actually leaning on cutting the plug out and reconnecting. I'm kind of leaning towards using connection boxes as shown on picture. That way I can...
Leave a comment:
-
I disconnected the plug again and 4 of the pins came out with the female connectors on them and wires broken and it’s obvious the wires were corroded...
Leave a comment:
-
Excellent thanks. This should work if I decide to go this route. I will open it again and try to locate the wire giving me issue. If it’s a single wire...
Leave a comment:
-
I think I have found my problem (if I didn't create a new one). I opened the wire harness plug (see picture) to see if all the pins were looking good...1 Photo
Leave a comment:
-
I did a voltage test with ignition switched on and motor not running. Now it has electronic ignition so there are no points to connect as the Stern Drive...
Leave a comment:
-
Ok, that's really great to know. No water in oil so I'm very happy to be able to strike it off my list.
Checked man over board switch and...
Leave a comment:
-
Thanks, I will continue the search. Starting at the ignition switch, the man-overboard switch and so forth. The stern drive manual is good for troubleshooting....
Leave a comment:
-
Thank you all. My mystery continues. I considered replacing points and other ignition parts, but then decided to go for electronic ignition and an ESA...
Leave a comment:
-
Thanks everyone. I have at least 3 things to test. The cap and rotor, the ESA by trying to disconnect it when this happen next. And the ignition coil....
Leave a comment:
-
Thanks for the advise. I will try to install the old rotor and cap and see if it makes a difference. I have replaced the impeller few times during the...
Leave a comment:
-
The only thing I haven't touched is the ESA module. A) I was wondering if the ESA could cause trouble like this? How would I disable the ESA module? Will...
Leave a comment:
-
Thanks Mike, yes timing is correct, both on timing belt and also ignition timing. I have not done compression test, but when it's runs it runs really...
Leave a comment:
-
OMC Cobra 2.3l running issues
Hi,
I bought my OMC cobra about 5 years ago. When I bought it I replaced main ignition parts adjusted the timings, rebuilt the carburetor...
No activity results to display
Show More
Leave a comment: