pgiconch
Supporting Member
Last Activity: Today, 04:51 PM
Joined: 06-14-2017
Location: Punta Gorda, Fl
-
Sorry to hear that, but good on the JB hatch find. Your plan sounds good to me, but I haven't done mine as it is still holding. I did replace the starboard... -
Prayers for a speedy and complete recovery. -
Umbrella seems to be a clear winner. Going with that. -
Having a new one made Doug. Not just the center pocket went, but the front pocket threads were mostly rotting and STBD side zipper was missing teeth....Leave a comment:
-
Glad I read all the way to the end. I didn't pay attention to the original date and was going to send you the Norcold factory service manual. Good to... -
Yep. What they all said!
Leave a comment:
-
OP said it was a Norcold. Typical in the 02 2655's. -
BTW - that setup was typical of BL boats of that era. As seen, it will never get all the water out due to sitting up on that raised platform. Lots of...Leave a comment:
-
The blue part is the float, and the round black top (red bottom) next to it is the bilge pump.Leave a comment:
-
Stay up there in Destin this week. Seas (Gulf) will be a reported 11-12 foot starting Thursday according to the Naples/Ft Meyers TV this morning. :bi...Leave a comment:
-
Not sure what year your boat is, but I would first check the voltage to the frig at the fuse panel. Should be a large red wire at a 10amp fuse. See if...Leave a comment:
-
My local shop also zippers the pockets. Told me I could put the frame back on. Thanks Jeff....Leave a comment:
-
Bimini Top Replacement Question
So the center rail pocket to the original Bimini top finally gave out today, all the threads disintegrating. Local shop quoted same price as Leta's for... -
Not long after getting our 2655 in 2017 I opened the engine hatch dockside for post operation checks as I always do after an outing, and discovered a...Leave a comment:
-
That should work.Leave a comment:
-
OK, so attaching pics of the rams i used to replace my worn out ones. If you dont already have them, 2 other pics dhow the strut support types you would...Leave a comment:
-
C-ya, is your hatch similar on the 2150? Not familiar with that boat. We didn't weigh mine when we had it off, but my buddy and I estimated it at "a...Leave a comment:
-
When we purchased the boat none of the struts (cabin or engine hatches) functioned. I had part numbers tho so I didn't have to calculate anything, just... -
Fantastic job. That really looks good....Leave a comment:
-
Thanks Dave
No activity results to display
Leave a comment: