Announcement
Collapse
No announcement yet.
User Profile
Collapse
-
I would use either outdoor carpet adhesive, or contact cement.... both can be removed easier than the 3m products, and should hold it fine without coming...
-
because we dont know what "side" of the boat was exposed to the oncoming weather, its hard to guess where or how it got in.... but im going...
Leave a comment:
-
MonteVista, this is false information... nothing makes a terrible noise because of the slightest wind blowing across it.
As one who uses...
Leave a comment:
-
in our area, napa has the highest oil prices of any store.... but they do sell delo 400, where as the discount autoparts stores dont...
-
as for what i know about electricity, you can NOT have a circuit tell you if the device it is supposed to be turning ON, is actually making the device...
- Likes 2
Leave a comment:
-
costco partnered with chevron to market the delo400 under the kirkland brand, so its the same good oil that we have always used.
the delo400...
Leave a comment:
-
DONT use the yellow nylon... its not good quality... any rope that is proper for an anchor rode will be the stuff to use... or personally, i prefer to...
- Likes 1
Leave a comment:
-
for fuel management and safety, it is recommended that one should consider using only 1/3 of the capacity going out, and 1/3 of the capacity to get home,...
Leave a comment:
-
if you have an AC outlet on the boat, and the boat is plugged into shore power, ANY 120v outlet would work as long as its getting power to it ... you...
Leave a comment:
-
an upward loop is actually preferred if there is room for one without the ventline collapsing......
-
find out if the bracket rating is for a 2stroke or a 4stroke engine, as the difference in weight can be nearly double in some cases...
Leave a comment:
-
you can pull the top cap and it will show you the bearing, and the cup will be in the cap... the running surface on the cup should be shiny or very slightly...
-
for powerboats, the engines should to be fairly level for a proper oil change, and if the engine was ran after changing the oil, the oils WILL be mixed,...
Leave a comment:
-
my opinion is.... if the elaborate "band-aid" is done proper, it will outlast new tanks.... the stuff they use for lining fuel tanks is a type...
Leave a comment:
-
if you see the stops at the pump shaft, that is where the fine adjustments are made FOR THE ENGINE high and low idle rpm... a quarter turn may be about...
-
its not uncommon for them to be a little different, but not desirable either..... is it an electronic controlled engine or an older manual control type?........
Leave a comment:
No activity results to display
Show More
Leave a comment: