2850Bounty
2850Bounty
Supporting Member
Last Activity: Today, 11:29 AM
Joined: 10-28-2003
Location: Gresham, just east of Portland Oregon
-
1..... if you know the total volume of the fuel tank and the volume of the existing fuel, then you can calculate the volume of the air space above the... -
Rick's OMC Cobra to Merc or VP conversion clarifications!
As many of you know, I am a diehard Volvo Penta guy. Not just Volvo Penta....... specifically the AQ series.
I am happy to see that there... -
.........................Leave a comment:
-
That is a thread that was started just over one year ago.
Please read my content in that thread... it may answer a few of your question.
Also,...Leave a comment:
-
1.... that is correct!
2.... there are no combustion by-products being produced in the gear unit, so there is no need for Detergent oil....Leave a comment:
-
Keep in mind that the 270 requires 30W Engine oil (40W if in warm water) ....... NOT heavy gear oil.
Heavy gear oil can damage the slinger...Leave a comment:
-
Does this system offer "remote start"?
LOL
Leave a comment:
-
This is a little off topic, but what is the procedure for checking the oil level in a 270 outdrive? Screw it in, don't screw it in, how high up on the... -
I think that this thread should be moved to the Tech Section....Leave a comment:
-
...........
Leave a comment:
-
That top center grease fitting direct grease into the two plastic bushings.
There is no grease fitting for the V-ring seal.
...Leave a comment:
-
Turbon, those center hub units are Bearing Buddies.
The common misnomer about Bearing Buddies, is that they add grease to the bearings! They DO...Leave a comment:
-
This is a little off topic, but what is the procedure for checking the oil level in a 270 outdrive? Screw it in, don't screw it in, how high up on the... -
The universal drive shaft bellows would not cause that leak.
If the bellows was to leak, water may enter the interior of the flywheel cover via...Leave a comment:
-
The PDS bearings are inside of the flywheel cover. They often get overlooked and not replaced.
There is no known accurate method for checking their...Leave a comment:
-
Your first image shows the Volvo Penta 280 transom shield.
My suggestions:
.......Pull the collar steering fork and replace...Leave a comment:
-
JC3, keep in mind that a 1/2 ton truck will no doubt pull that boat...... but the important thing is that you don't want the boat/trailer to wag the tow...Leave a comment:
-
Yes, that was the most popular for that model boat.
I hope that our humor didn't scare the OP away!...Leave a comment:
-
I do not own a 2556. If I did, at minimum I would use a 3/4 ton truck with 4WD. Launch ramps can be slippery.
My trailer would be at least...Leave a comment:
-
We need more information!
Is this in regard to the Hurkendecker stern drive, or to the Quirkendickle inboard system?
Leave a comment:
No activity results to display
Leave a comment: