Kwood
Supporting Member
"1989 4588
EH 700TI"
Last Activity: Today, 05:07 PM
Joined: 12-02-2015
Location: Georgetown, MA
-
HUD regulations always prohibited illegal aliens in HUD public housing. That's a fact. Remember Auntie Zeituni? That was Obama's aunt who was in the... -
^^^
Agreed. That is why a galvanic isolator and silver/chloride half cell should be standard equipment.Leave a comment:
-
From my supplier:
"Sacrificial anodes must be impurity-free to properly work, and all our anodes are made only from Mil-Spec alloys....Leave a comment:
-
Try boatzincs.com -
^^^^
You may not have been exposed to voltage potentials that could cause galvanic corrosion. From my understanding that's not unheard of in fresh...Leave a comment:
-
Boatzincs.com/ Reasonably priced, fast shipping. Great customer service and tech support if you need it. Highly recommended. -
That's from an old post by Smitty477 I saved. It's on here somewhere.
2800RPM on my 4588 is 17kt +/-. Can do 22kts or more surfing down...Leave a comment:
-
Your camera broken?Leave a comment:
-
...
Leave a comment:
-
Temperature gradient is temperature gradient. You could use this EGT to measure anything within the type "K" temperature range of -454F to 2300F...Leave a comment:
-
Solved!
There is no port on the EH700TI and the pyro goes pre-turbo..... like I originally thought. The manifold can be drilled and tapped...Leave a comment:
-
Depends on the paint type coverage. My antifouling says 400 sf / gallon. The primer I'm using says 800 sf / gallon. So depends. Check the manufacturer...Leave a comment:
-
I just finished prepping my 1989 4588 for bottom paint. It's always had ablative. Three - four coats in some areas, Scraped to gelcoat 60%-70%. A few...Leave a comment:
-
On the Hino EH700TI there is no space between turbo and elbow....
Does this look like OEM Riser?...Leave a comment:
-
Nick
This is type "K" 24 gauge thermocouple wire. Supposed to be good for 100 feet. I ran 2X 30 feet from pilot house gauge panel...Leave a comment:
-
Is anyone still running with OEM risers on the EH700TI? There's supposed to be a plug near the turbo interface where a pyro probe can be installed. Damned...Leave a comment:
-
You can probably save some money. Just put a 2nd smaller smart charger in.
What are the specs on the original charger?
ETA 2...Leave a comment:
-
@mickklass
What Destiny is saying.
I'm doing the same thing right now - wifi. There's no way to get below at the scupper. You'll have...Leave a comment:
-
1989. Flybridge built-ins removed long ago. I have the two 8" for arch access and a 6" stb at that drain. I believe the 6" was not OE...Leave a comment:
-
In slack water like that it's fine. In fact - you want to try to keep the snubber above water if it's nylon. Nylon loses significant stretch and strength...Leave a comment:
No activity results to display
Leave a comment: