Mr._Darcy
Supporting Member
Last Activity: 11-06-2019, 12:10 PM
Joined: 09-21-2015
Location: South Beach Marina, Newport, Oregon
-
Both of the above ideas are good ones IMHO. Something you can do as a diagnostic is to turn off the breaker, turn the thermostat to go as cold as it... -
It has been a while back that someone on BOC was removing the rectangular deep bowl double sink to install a single rectangular single sink that was...Leave a comment:
-
Call the manufacturer, explain the application, where installed etcetera, and ask what other gases could possibly be affecting the sensor. Personally...Leave a comment:
-
It may be that one of the manicooler end cap O rings is leaking. Drain the coolant from the manicooler and remove both end caps. Inspect the O rings and...Leave a comment:
-
1986 3270 with Hino 110 HP engines. Pretty much the way it came from the factory. Furuno 1621 Radar, Furuno GPS/Plotter/Fish Finder. Standard Horizon...Leave a comment:
-
First find out what material the tank itself is made of from the manufacturer. Then go on Amazon and purchase the appropriate anode/drain plug combo...Leave a comment:
-
I have seen brightwork protected in that fashion but had not thought about carrying it down to also protect the coaming upholstery. thanks.
...Leave a comment:
-
When you get the old tank out it would be worth it IMO to see if it is repairable. Repairing and epoxy coating (3 or more coats) can save a boat buck...Leave a comment:
-
You can use a hot air plastic welder to repair polyethylene tanks. Harbor Freight has an inexpensive one that can be used with relatively small air compressors....Leave a comment:
No activity results to display
Leave a comment: