floatyerboat
Supporting Member
Last Activity: Today, 07:12 PM
Joined: 02-10-2015
Location:
-
I'd drill a bigger drain hole inside the chain locker. You are taking on water faster then that tiny hole can drain it. Because the hole in the deck is... -
I'm lost on this one guys. I added a windlass and it wasn't until the wet chain was retrieved that the monkey fur around the wooden hatch started to mold...Leave a comment:
-
What I found out on my 32 was the original backrest on the seating of the flybridge was not vented and moisture trapped inside rotted the wood frame....Leave a comment:
-
When I bought my boat I had the same problem. Half of the guts for the pulls were missing but I still had the round pull buttons. I to searched but found...Leave a comment:
-
without trying to sound like a smart ass did you try lifting the gas tank off that shiny new fiberglass floor?Leave a comment:
-
Just remember if you have a cover on the hatch that it has to be removed for the A/C unit to work properly. The unit needs good airflow over the coil...Leave a comment:
-
Did you put the rubber impeller of the pump in backwards? If it starts look to see if you are getting a sufficient amount of water coming out of the ...Leave a comment:
-
On my 88 3218 I have central air with the unit sitting right behind the waste tank in the cave. I just had it replaced two years ago and it works great....Leave a comment:
-
I recently installed two 2 inch Searay engine synchronizer gauges along with a synch module to fine tune. I was running out of space on the instrument...Leave a comment:
-
Come to think of it when I use my horn, one or two of my gauges red line. I'm also finding out a 30 year old boat was not designed with all this new technology...Leave a comment:
-
I assume you mean when you turn the motors off. My tachs read accurate while underway but the starboard side lower helm will occasionally stick just below...Leave a comment:
-
I wonder if your cig lighter isn't at fault. If your gauges are pegging that might mean the cig lighter is wired into the ignition system and that aint...Leave a comment:
-
My tach's don't have any selector switch on back at all. They are stamped " for 8 cylinder engines only '. When I turn the engines off the starboard...Leave a comment:
-
Trim tabs stuck in the down position? I'm sure your hired captain was using them on the way to Florida. Lots of drag there. Sounds funny but it happened...Leave a comment:
-
I bought a 6hp Honda, 4 stroke kicker for my 18 ft. alumacraft fishing boat. It pushes it along nicely. It has the internal tank plus external connection...Last edited by floatyerboat; 07-29-2018, 04:37 PM.Leave a comment:
-
good to hear it wasn't a shaft, that would suckLeave a comment:
-
Just last Friday the dude in the slip next to me has a 2000 Sea Ray had to pull the fridge to get at something. He found out why his beer didn't stay...Leave a comment:
-
I have a older model kohler genny but similar. I had the same problem two years ago. I was told to put a load on the genny like turn on the microwave...Leave a comment:
-
or borrow your neighbors angle drillLeave a comment:
-
I drilled a pilot hole before going in with the arbor bit. It looked like the dash chipped more with the 1/8 inch pilot bit then it did with the new 2...Leave a comment:
No activity results to display
Leave a comment: