Destiny_4588
Supporting Member
Last Activity: Today, 08:10 PM
Joined: 09-25-2007
Location:
-
Thanks for sharing, the drip less seals all have spec of allowable tolerance for being true/round, if they are out the seal cannot seal correct, we had... -
Are shafts out true or are the shafts out of alignment with the engine? Shaft engine alignment is a common adjustment especially if you are replacing...Leave a comment:
-
I will not even tell how much a 50' 125/250 cord costs these days, makes this one look like a super bargain.Leave a comment:
-
I highly suggest you not loose those hatches, they are access to the hose clamps for the fill and vent and tank sensor. These are route maint areas (ie... -
YES, we had to open this area up to repair our upper water tank and do some other upgrades of the years, at the time we added a few addition support cross...Leave a comment:
-
Heat is in the Engine room, the air heated to cool the AC generator portion, my engine does NOT get hot when on the hook and we just run the gen set now,... -
Make sure you are getting agreed value policies Geico/Boat US, I think there have depreciation in them so if you have big loss your pay out is reduce....Leave a comment:
-
in my experiences you have a few things going on here Older boats my is a 1990 and that seems to drive recent surevey (2-3 years seems to be recent) and...Leave a comment:
-
my point is why have to do all that aftermarket stuff when out of the box a Fisher Panda is designed to be quiet and run cooler. Just saying I own one... -
Part of what makes gen sets noisy is that the AC generator/Exciter component is AIR cooled on most models (Onan, Northern Iights, so on), so the sound...Leave a comment:
-
WE have 1990 4588, we did a 15Kw Fisher Panda about 3 years ago. It is the quiet option, least vibration and cool temp as they have a unique design where...Leave a comment:
-
On our 4588 we did this 20 years ago and have love it!
just recently switched to a lighter aluminum boat dingy and use weaver chocks and...Leave a comment:
-
I did the same and the values I used also had a signal wire for indicator lights, so you can get a Green light for open and Red Light for closed so you...Leave a comment:
-
I have my 50 ton Masters now (start with OUPV 5 yeras ago) ....Insurance is less for my boat by 15% ish, you can take your boat on longer offshore or...Leave a comment:
-
+1 on not enough air/ over load. Try cleaning air filters or installing new ones and see if that changes things. ....another possible issue are your...Leave a comment:
-
on our 1990 4588 it just lifts up, it is held in place with an L shaped wood bracket.... -
Same tray Idea but ours drains lower stern bildge by water heaters (Not to area in 2nd guest room). I use heat gun and do ours as soon as the refer has... -
Our runs onthe port side valance and into the wall and out a small hole for two small reading like lights. Look for BLUE wires. Blue wires on 4588 are... -
All refers will do this with no power. The easy solution for us was two fold. I when we added solar panels, we choose to run it on DC ONLY so the dock...Leave a comment:
-
Underhulls are like a cup filled with foam and glued to bottom. This can leak and this why we choose to NOT use that product and go with glass and laminated...
No activity results to display
Leave a comment: