BTW:
HMS did everything. Came to boat, helped with selection of type of mat, measure precisely, delivered, & hauled off....
Announcement
Collapse
No announcement yet.
User Profile
Collapse
-
INSURANCE RENEWAL ISSUE
My 1990 4588 is currently insured with United Marine Underwriters and is up for renewal. However, they are telling me that they must place me with another...
-
All of my water fixtures have been change to Moen knock-offs. The galley knock-off has a small in-line filter in the sprayer/spout which maybe clogged...
Leave a comment:
-
Received the SuperBright LED 7” pucks. Looked great online. Read the instructions and turns out they are 12w 120v, crap. Back they go. I did finally...
Leave a comment:
-
Thanks for input. I’m on dockside water most of the time. Never open shore water tap more than 30% . I have replaced 3 Jabsco pressure regulators....
Leave a comment:
-
4588 Water pressure at sink
Water pressure on shore water at the sink is a trickle but down below all of the fixtures are satisfactory. I’ve cleaned the defuser and screen to no...
-
I noted a leak from my wind shield which dribbled to the interior channel you described. It ultimately dripped down and on to the pilot house door step...
Leave a comment:
-
All though we don’t claim to be live board, we are alotta aboards spending months at a time aboard and have no real other expenses at our Airstream...
Leave a comment:
-
Did not find any ID on the dome can. Did find a local tech who has 10 of these pulled from a remodel. He’s bringing one by to see if it will do. In...
Leave a comment:
-
Another thing to check are the latches. There is an O ring in each handle stem assembly. It the O ring is deteriorated or crushed you will get a dribble...
Leave a comment:
-
Found something at SuperBright. Appear to be as thin and fit flush in existing mount frame. 7” brass toned trim rings w/bright LED plate rather than...
Leave a comment:
-
Thanks Mark. Did not see a 7” ceiling light similar or same as the OEM 12v bulb Light w brass trim ring. I replaced all of the original bayonet bulbs...
Leave a comment:
-
Recessed brass ring puck light source
Tried to resolve a polarity problem on a recessed 12v overhead light in the master berth of my 1990 4588. Lead wire attached to the bulb receiver was...1 Photo
-
Greenwater! Replaced both in early 2020. Price was good. Outstanding product, boat jewelry. Also did turbos....
Leave a comment:
-
Never ever use FLEX SEAL! It rarely solves anything. If your going to do it, do it right.
Re-bed the windshield panes.
Or if you want to...
Leave a comment:
-
Our solution was to remove the OEM central vac and bite the bullet for the Dyson V10. Amazing performance, no cord, and used daily. Same product on my...
Leave a comment:
-
The holding tank vent line is possibly clogged. If there is a vent filter, it is probably clogged and packed with a surprise. You should be able to visually...
Leave a comment:
-
Midday Plastics in Bellingham Wa should have the Patterns to reproduce. They did most of the Venturi(s) for Bayliner....
Leave a comment:
-
KWOOD, I’ll check that vent you referenced.
I put the two clam shells on the starboard side and it did help resolve the dribble to the cabinet...
Leave a comment:
No activity results to display
Show More
Leave a comment: