yachtman
Guru
Last Activity: Today, 08:27 AM
Joined: 03-07-2007
Location: Pacific northwest usa somehwere around spokane wa.
-
Yep agree 100% and here is a good example of that. I own my own business. I haven't raised my prices for a while and sometimes I could feel the pinch.... -
I used to take my 21 ft sunrunner out of depoe bay oregon probably 5 miles to open ocean. No special equipment just a vhf radio and required equipment....Leave a comment:
-
I feed mine into the shore power with a switch to transfer generator / shore power / inverter. It would run through you existing ac power panel no need...Leave a comment:
-
Hold on a minute!!! Part of the whole point of these tariffs (I don't believe in tariffs) is the fact that China has /is devaluing its currency. so...Leave a comment:
-
That's just ridiculous it can get bad out there even so much that a 30-40ft boat shouldn't be out there but then I took a boy scout troop across Rosario...Leave a comment:
-
The fist picture is a little cove I think it's called crab cove but not sure. It's just north of oak harbor heading toward deception pass. The other is...Leave a comment:
-
Decatur bay, jones island ,James island the picture is Decatur bay @ Decatur island ,Rosario beach just outside of deception pass. I also like west side...Leave a comment:
-
Where is a plastic magnet when you need one. Time to invent you'll be rich.Leave a comment:
-
The only harm I can see it doing is get chopped up enough to plug up the oil pick up tube screen however that may never happen.
i had an...Leave a comment:
-
This isnt necessarily correct....
much of the California farm area lays dead or dormant from permission to use the water. I drive through...Leave a comment:
-
Leave a comment:
-
If you want to run a HD transducer or a side scan you have to put.the transduce.on the outside. Otherwise I would probably put it inside th hull somewhere....Leave a comment:
-
Uep.Washington state is falling off the edge too. In spokane area and spokane county the government has ban all new well drilling. Has a lot of raw land...Leave a comment:
-
Usually those aren't removable. You need to drill a hole large enough for it to pass through, then you cover the hole with a stainless clam shell. Then...Leave a comment:
-
Anyone care to make a bet that's going to be Smoot Hawley all over again?Leave a comment:
-
I agree somewhat but making it impossible to fabricate something is not the right way and getting some other country trash the world in the name of our...Leave a comment:
-
We screwed up in my opinion when we did NAFTA. I don't think tariffs is the way to fix it. I think the government offering massive subsidies to reboot...Leave a comment:
-
I will say I am not the smartest on this subject but trump haters or lovers aside...... history has proven tariffs don't work and not only do they not...Leave a comment:
-
I just replaced my windless chain. $1200
Leave a comment:
-
This was kind of my point on the low costs per year.
you still don't mention exhaust risers / manifolds( well you had them on the list) (...Leave a comment:
No activity results to display
Leave a comment: