I have to rebuild or replace my port motor cummins b series 330 any experience on removal of engine and how to get it out of cabin. it is under kitchen
Announcement
Collapse
No announcement yet.
REMOVE PORT ENGINE FROM 4087-gctid828064
Collapse
X
-
GuestTags: None
-
I noticed that you are a relatively new member to the BOC forum. Please complete your profile and signature. This will make it easier for others to help you.
1999 3788, Cummins 270 "Freedom"
2013 Boston Whaler 130 SS
Anacortes, WA
Isla Verde, PR -
I have wondered about the best method for such a service. I hope not to have remove an entire engine anytime soon in our 3587.
I speculate that it might be a piece by piece disassembly in the boat in order to get the block assemble small enough to fit out a window opening.
I would expect to remove the galley, dinette and floors sections on the port side.
Please keep this post updated with your solution.
1995 Bayliner 3587
Twin Hino 250HP
Located In Sidney BC, CanadaComment
-
I suggest you speak with Tom at Inlet Marine in Port Moody BC (604) 936-4602. They have replaced engines on a couple of 4087's in the last two or three years. I'm sure that they would be happy to give you advice.
Rob
Bayliner 5788
'Merlin V'
Vancouver BCComment
-
"Thisldu1" post=828064 wrote:
I have to rebuild or replace my port motor cummins b series 330 any experience on removal of engine and how to get it out of cabin. it is under kitchen
Comment
-
I've seen a couple of them lifted out. Often they'll boom in through a window to get the stripped block above the deck plates, and then sit it down temporarily to lift it out through the rear doors.
Comment
Comment