Announcement

Collapse
No announcement yet.

Shifter Detents-gctid825636

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • Dunwoody
    replied
    Thanks for the advice. I assume that entire shifter mechanism is bolted from underneath. By loosening those bolts I can raise the assembly to gain access to the adjusting screw.

    Thanks again.

    Jim

    Leave a comment:


  • boatbum
    replied
    Superior Diver is correct also. On my 38, the detent adjustment is on the flybridge controls.... as is the "start in gear" protection switch

    Leave a comment:


  • SuperiorDiver
    replied
    Boatbum is correct, but if I remember correctly, when I did mine, you only adjust the detent at one station. The manual is on the boat so I cannot look it up for you

    Leave a comment:


  • boatbum
    replied
    They are adjustable, but the shifter has to be partially removed to get at it.

    On the side of the unit just under plate, you will see a screw which when tightened compresses a spring on to a ball bearing.

    Leave a comment:


  • Dunwoody
    started a topic Shifter Detents-gctid825636

    Shifter Detents-gctid825636

    Would like advice to tighten the shifter detent

    on 4087. They do detent, but too easily move from neutral to in-gear. There must be an adjustment somewhere?
Working...
X