3788 How to pull new wires to upper helm-gctid803469

[p91473]

Installed a new transducer and am now having problems running the wire to the upper helm where the new fish finder is. I have not done this on a 3788. Can someone chime in on where the tube is that runs up and how to access it.

Thanks

[Norton_Rider]

There are two tubes right below the upper helm throttles. They end up next to the lower hem seat. Take off the upholstered panel just above the floor and forward of the lower helm seat.

[uffdakev]

I had to remove the larger panel next to the lower helms seat. The one that contains the electrical outlet and thermostat. The previous owner had radar installed, and this filled a pinch point in the run from the upper helm.

[p91473]

"uffdakev" post=803599 wrote:
I had to remove the larger panel next to the lower helms seat. The one that contains the electrical outlet and thermostat. The previous owner had radar installed, and this filled a pinch point in the run from the upper helm.

Thanks to you both. I was able to run the new transducer by remove above referenced panels.