Announcement

Collapse
No announcement yet.

2850 on a trailer - How tall a garage door?-gctid378371

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • Guest
    Guest replied
    Thanks for the feedback.

    It sounds like 14' is the magic number. It is a sort of chicken and the egg situation. I have neither the trailer nor the outbuilding yet.

    Ron

    Leave a comment:


  • Guest
    Guest replied
    [img]/media/kunena/attachments/vb/681964=27336-024.jpg[/img]

    [img]/media/kunena/attachments/vb/681964=27337-026.jpg[/img]this is one way to go

    [img]/media/kunena/attachments/vb/681964=27338-boat home 003.jpg[/img]or the real way into a 14 ft door with inches to spare . i broke a light bulb going in. my advice is but as high a door as your building will allow

    Leave a comment:


  • kwb
    replied
    Have 14' door - boat used to clear by 7-8" with the arch folded down.

    Built the shop knowing that I would have a boat that would be close to max legal height.

    There was adjustment in the trailer that I could have gotten a few more inches down but I liked it being a bit higher so I only had to tilt the drive a little bit when I came out of the water to move it around the lot that I stored at during the summer.

    Leave a comment:


  • Guest
    Guest replied
    Bellingham_2850 wrote:
    Hi,

    I'm looking into purchasing a trailer for my '86 Contessa Command Bridge. Does anybody have the same setup and park it in a garage? I'd like to know how high of a door to install in the outbuilding.

    Thanks

    Ron
    Ron,

    I have the 84 2850 Contessa with Command Bridge and load mine on a bunk trailer. I store it in a warehouse during the winter and the warehouse has a 12 foot high door. My boat clears the door by 1/8th an inch. My truck has airbags and I have to empty them to get the 1/8th inch clearance. You also need to be aware of the width, as you have a 9.5 foot beem so the door should also be at least 12 feet.

    Leave a comment:


  • Jeffw
    replied
    My 305 sunbridge was 13'6" on the trailer, the current 2858 is 13'7" on the same trailer. The 14' door is good advice. The permanent cover over my parking area is 14' and clearances are fine, without antennas...

    Leave a comment:


  • 2850Bounty
    replied
    Ron, my older 2850 version is a tad bit larger than your 2850 version, and I don't believe that I've ever measured mine before.

    I can look out a second story window in my home, and view the upper most part of my boat. I'd have to say that if it were to come into the structure, it would be about 3 feet above that floor level, which would be roughly 13 1/2 feet.

    Looks like you'll need to have someone with the same boat pull a string line level across the highest portion and take a measurement to the ground.

    I think you'll need a fairly tall door for it.

    .

    Leave a comment:


  • Guest
    Guest replied
    My buddy trailers a 28ft contessa, he must pull off the radar arch to get into anythiny under 13ft 2". He makes it onto the ferry okay tho! It will also depend on your trailer, best to do is measure it if you can I would not put anything smaller than a 14ft door. After that I believe you'll need the engineers

    Leave a comment:


  • Guest
    Guest started a topic 2850 on a trailer - How tall a garage door?-gctid378371

    2850 on a trailer - How tall a garage door?-gctid378371

    Hi,

    I'm looking into purchasing a trailer for my '86 Contessa Command Bridge. Does anybody have the same setup and park it in a garage? I'd like to know how high of a door to install in the outbuilding.

    Thanks

    Ron
Working...
X