Welcome, Guest
Username: Password: Remember me
  • Page:
  • 1

TOPIC: Removing Inside Bumper Pads

Removing Inside Bumper Pads 18 Jun 2009 00:28 #1

  • JTCNB
  • JTCNB's Avatar Topic Author
  • Offline
  • Junior Member
  • Junior Member
  • Posts: 99
  • Thank you received: 0
Hello,

Is it a BIG job to remove these bumper cushions that appear to be installed where the bottom and top half of the boat forms?

I would like to remove these and recover them as I am in the mist of re-upholstering all the interior cushions. (That is if it is not like pulling teeth!)

Attached files

This image is hidden for guests.
Please log in or register to see it.

Please Log in or Create an account to join the conversation.

Terry
1989 2455 Cierra 5.8l
Garmin 176C
2003 F-150 SuperCrew 5.4l

Removing Inside Bumper Pads 18 Jun 2009 00:36 #2

  • Canemah_Patriot
  • Canemah_Patriot's Avatar
  • Offline
  • Senior Member
  • Senior Member
  • Posts: 168
  • Thank you received: 4
Try searching earlier threads. I know I've seen the answer to this question, but I'm not sure I remember it right: I think you have to pull the plastic strip out of the rub rail on the outside of the boat, and then you will have access to screw heads that hold the upholstered panels in place.

Please Log in or Create an account to join the conversation.

Ken & Linda, Canemah Oregon
1984 Bayliner 2750 "Patriot"
  • Page:
  • 1
Moderators: Jim GandeeRuffryder
Time to create page: 0.070 seconds
Powered by Kunena Forum