Welcome, Guest
Username: Password: Remember me
  • Page:
  • 1

TOPIC: bridge enclosure for 3270/3218/3288??

bridge enclosure for 3270/3218/3288?? 01 Feb 2010 16:54 #1

  • BrooklynJim
  • BrooklynJim's Avatar Topic Author
  • Offline
  • Elite Member
  • Elite Member
  • Posts: 531
  • Thank you received: 0
hey guys.. anyone know who's making them? i tried leta but she doesnt have the templates and since i dont have the old ones, its either a custom job or find used, which im ok with.. but im back to square one, they are just not out there

so after receiving some quotes from locals, i thought ide ask here

Please Log in or Create an account to join the conversation.

Bayliner 3270
"MARAKI"
Twin Crusader CH220's
(repowered)
Important Notice"
DUE TO RECENT BUDGET CUTS, STOCK MARKET PERFORMANCE, RISING COST OF ELECTRICITY, GAS AND OIL...
THE LIGHT AT THE END OF THE TUNNEL HAS BEEN TURNED OFF....
WE APOLOGIZE FOR THE INCONVENIENCE
Regards
THE GOVERNMENT
[/SIZE]

bridge enclosure for 3270/3218/3288?? 01 Feb 2010 21:33 #2

  • Papa Charlie
  • Papa Charlie's Avatar
  • Offline
  • Platinum Member
  • Platinum Member
  • Posts: 2520
  • Thank you received: 165
It has been my experience that you can't buy one of these off the shelf. They just don't fit right and therefore don't look right either.
Everyone makes the frames a little different. Therefore, the canvas must be made to match the frame.
Good luck.
Pat

Please Log in or Create an account to join the conversation.

Patrick and Patti
4588 Pilothouse 1991
12ft Endeavor RIB 2013
M/V "Paloma"
MMSI # 338142921

bridge enclosure for 3270/3218/3288?? 02 Feb 2010 03:24 #3

  • MikeM8560
  • MikeM8560's Avatar
  • Offline
  • Senior Member
  • Senior Member
  • Posts: 177
  • Thank you received: 0

Papa Charlie;413255 wrote: It has been my experience that you can't buy Everyone makes the frames a little different. Therefore, the canvas must be made to match the frame.
Good luck.
Pat

Thats what Im thinking also my 32 has the frame mounted on the top of the bridge with w horisontal ceck mount but it also had vertical side mounts on the outside of the bridge from maybe the stock position? I just removed my canvas and made new patternts for my boat this weekend and though about saving the pattern. odd thing is all my 1" stainless frames are welded in the center. the canvas had a gogia sails lable. did they make them for bayliner back in 88?

Please Log in or Create an account to join the conversation.

bridge enclosure for 3270/3218/3288?? 02 Feb 2010 03:28 #4

  • Papa Charlie
  • Papa Charlie's Avatar
  • Offline
  • Platinum Member
  • Platinum Member
  • Posts: 2520
  • Thank you received: 165
I doubt it. Most canvas was provided by the broker or installed by canvas shops through a PO. I don't think Bayliner installed any canvas on the motoryachts.
Pat

Please Log in or Create an account to join the conversation.

Patrick and Patti
4588 Pilothouse 1991
12ft Endeavor RIB 2013
M/V "Paloma"
MMSI # 338142921
  • Page:
  • 1
Moderators: JeffwAlaskanmutt
Time to create page: 0.077 seconds
Powered by Kunena Forum