Welcome, Guest
Username: Password: Remember me
  • Page:
  • 1

TOPIC: 1986 Capri bell housing swap

1986 Capri bell housing swap 09 Jan 2008 03:29 #1

  • bwilbert
  • bwilbert's Avatar Topic Author
  • Offline
  • New Member
  • New Member
  • Posts: 2
  • Thank you received: 0
I had a crack in the bell housing. Pulled motor in my driveway. Put new driveshaft, Bellows, Water elbow, bearings, & seals. Also put Pertronix ignition in. Found out Dual battery installation was terrible. Lugs were not crimped or soldered and one wire fell out. Crimped cables and made all correct. Took it out in San Diego bay and works great.

This image is hidden for guests.
Please log in or register to see it.


This image is hidden for guests.
Please log in or register to see it.


This image is hidden for guests.
Please log in or register to see it.


This image is hidden for guests.
Please log in or register to see it.

Please Log in or Create an account to join the conversation.

1986 Capri bell housing swap 09 Jan 2008 05:14 #2

  • 2850Bounty
  • 2850Bounty's Avatar
  • Offline
  • Platinum Member
  • Platinum Member
  • Posts: 24478
  • Thank you received: 1121
Wait a minute! This is an advertisement for one of those "Little Giant" Ladders, right?

And the all new Volvo Penta engine pulling ladder!

This image is hidden for guests.
Please log in or register to see it.

Please Log in or Create an account to join the conversation.

Rick E. Portland, Oregon
2850 Bounty Sedan Flybridge model
Twin 270 HP 5.7's w/ Closed Cooling
Volvo Penta DuoProp Drives
Kohler 4 CZ Gen Set

1986 Capri bell housing swap 14 Jan 2008 15:13 #3

  • garry454
  • garry454's Avatar
  • Offline
  • Senior Member
  • Senior Member
  • Posts: 203
  • Thank you received: 0
That's one of those environmentally friendly Volvos. You can tell by the plant growing in the bilge. :kidding

Please Log in or Create an account to join the conversation.

  • Page:
  • 1
Moderators: whiskywizarditsabowtime2
Time to create page: 0.075 seconds
Powered by Kunena Forum