| | | |
|
|
|
|
|
I will use the return vent thats shared with the AC unit. I moved it from the left to the right side. Viewed: 685 times.
|
With the return vent moved I have an area to mount the heatercraft. Viewed: 627 times.
|
The HW supply and return line for the heater will come in next to the raw water supply for the AC unit. Viewed: 570 times.
|
In order to be able to work in the access area I had to cut the AC supply duct. It was too short to put back together so I ended up replacing it. Viewed: 533 times.
|
| | | |
| | | |
|
|
|
|
|
Now I have all sorts of room to work. First I moved the Grey conduit for the AC unit. Viewed: 520 times.
|
I need a flat spot to mount an L shaped board that will be used to support the heater. I notched the rail that was the routing point for the grey conduit. Viewed: 468 times.
|
I pulled the control unit for the AC to see how the wires were run. I will route the wires for the heater through the same hole. Viewed: 476 times.
|
Heater control switch installed. Viewed: 579 times.
|
| | | |
| | | |
|
|
|
|
|
Installed one of two of the euro vents. Installed here so if Vberth was installed it would not restrict the air flow under the cushions. Viewed: 545 times.
|
The 3 inch hose was run from the vberth under the sink in the head and then follows same route as the AC duct. The wires are for the fan unit on the heater. Viewed: 485 times.
|
Used a 30 AMP fuse holder with the recommended 15 amp fuse. Viewed: 565 times.
|
Vent two is in the cockpit. These euro vents are cool. Not only do they have a closable louver, but they rotate 360 degrees. Viewed: 534 times.
|
| | | |
| | | |
|
|
|
|
|
Mounted the heater to the board and did a dry fit. It fits. Now to paint the board. Viewed: 562 times.
|
Drilled the holes for the HW hoses. Viewed: 485 times.
|
HW hoses routed. Installed bypass for summer months. Viewed: 575 times.
|
Hoses installed in bulkhead from engine compartment. Viewed: 523 times.
|
| | | |
|
|
|
All done. Ready to re-install access panel. Viewed: 577 times.
|
|
